Chemspray garden insect spray

Product Name: FoliMAX Phosphite +
Page: 1 of 4
Issued: August 2013
FoliMAX Phosphite +
Section 1 - Identification of Chemical Product and Company
Amgrow Pty Ltd
Phone: (02) 9395 1200(Business hours)
PO Box 6390
Fax: (02) 9395 1241
Silverwater NSW 1811
Trade Name:
FoliMAX Phosphite +
Product Use:
Combination fungicide and root stimulants Issue Date:
August 2013
Section 2 - Hazards Identification
Statement of Hazardous Nature
NOT CLASSIFIED AS HAZARDOUS ACCORDING TO THE CRITERIA OF SWA
NOT CLASSIFIED AS A DANGEROUS GOOD ACCORDING TO THE CRITERIA OF THE ADG CODE
SUSMP Classification: None allocated
ADG Classification:
Packaging Group:
UN Number:
Hazchem Code:

Emergency Overview
Physical Description & colour: Clear orange liquid
Odour: Minimal acidic odour
Major Health Hazards: No significant risk factors have been found for this product.
Potential Health Effects
Inhalation: No adverse effects expected
Skin Contact: Product may cause irritation of the skin
Eye Contact: May irritate or damage eyes
Ingestion: Ingestion of large amounts may cause gastrointestinal disorder, nausea, diarrhoea, vomiting,
Carcinogen Status:
SWA: No significant ingredient is classified as carcinogenic by SWA
NTP: No significant ingredient is classified as carcinogenic by NTP
IARC: No significant ingredient is classified as carcinogenic by IARC
Section 3 - Composition/Information on Ingredients
Ingredients
CAS No
This is a commercial product whose exact ratio of components may vary slightly. Minor quantities of other non hazardous ingredients are also possible. MATERIAL SAFETY DATA SHEET
Product Name: FoliMAX Phosphite +
Page: 2 of 4
Issued: August 2013
Section 4 - First Aid Measures
General Information: You should call The Poisons Information Centre if you feel that you may have been
poisoned, burned or irritated by this product. The number is 13 1126 from anywhere in Australia (0800 764
766 in New Zealand) and is available at all times. Have this MSDS with you when you call.
Inhalation: If mists have been inhaled, and irritation has developed, remove to fresh air and observe until
recovered. If irritation becomes painful or persists for more than about 30 minutes, seek medical advice
Skin Contact: Wash affected areas with water until chemical is removed. Remove all contaminated
clothing and launder before re-use. If in doubt obtain medical advice.
Eye Contact: Immediately irrigate with copious amounts of lukewarm, gently flowing water for 15 – 20
minutes or until the product is removed or irritation has ceased, while holding the eyelid(s) open. Obtain
medical advice if irritation becomes painful or lasts more than a few minutes.
Ingestion: Give a glass of water if affected person able to drink. Do not induce vomiting unless instructed
to do so by medical advice.
Notes to Doctor: Treat symptomatically.
Section 5 - Fire Fighting Measures
Fire and Explosion Hazards: Product will not cause or contribute to an explosion. If in a fire product
decomposition may result in the generation of toxic fumes.
Extinguishing Media: Not Combustible. Use extinguishing media suited to burning materials.
Fire Fighting: If a significant quantity of this product is involved in a fire, call the fire brigade.
Flash point:
Upper Flammability Limit: Does not burn.
Lower Flammability Limit: Does not burn.
Auto ignition temperature: Not applicable - does not burn.
Flammability Class:
Section 6 - Accidental Release Measures
Accidental release: In the event of a major spill, prevent spillage from entering drains or water courses.
As a minimum, wear overalls, goggles and gloves. Stop leak if safe to do so, and contain spill. Absorb onto
sand, vermiculite or other suitable absorbent material. Sweep up and shovel or collect recoverable product
into labelled containers for recycling or salvage. After spills, wash area preventing runoff from entering
drains. If a significant quantity of material enters drains, advise emergency services. Full details regarding
disposal of used containers, spillage and unused material may be found on the label. If there is any conflict
between this MSDS and the label, instructions on the label prevail. Dispose of only in accord with all
regulations.
Section 7 - Handling and Storage
Handling: Check Section 8 of this MSDS for details of personal protective measures, and make sure that
those measures are followed. The measures detailed below under "Storage" should be followed during
handling. Also, avoid contact or contamination of product with incompatible materials listed in Section 10.
Storage: Store in a cool, dry place away from children and animals or foodstuffs. Ensure containers are
labelled, protected from physical damage and sealed when not in use. Store away from farm chemicals
e.g. insecticides, fungicides and herbicides. Containers should be kept closed in order to minimise
contamination. Keep from extreme heat and open flames, and make sure that the product does not come
into contact with substances listed under "Materials to avoid" in Section 10.
Section 8 - Exposure Controls and Personal Protection
Exposure Limits TWA (mg/m3) STEL (mg/m3) ADI (mg/Kg/day) NOEL (mg/Kg/day)
Exposure limits have not been set for any ingredients in product. The TWA exposure value is the average airborne concentration of a particular
substance when calculated over a normal 8 hour working day for a 5 day working week. There is a blanket limit of 10mg/m3 for dusts or mists when
limits have not otherwise been established. The STEL (Short Term Exposure Limit) is an exposure value that should not be exceeded for more than
15 minutes and should not be repeated for more than 4 times per day. There should be at least 60 minutes between successive exposures at the
STEL. The term "peak "is used when the TWA limit, because of the rapid action of the substance, should never be exceeded, even briefly.
MATERIAL SAFETY DATA SHEET
Product Name: FoliMAX Phosphite +
Page: 3 of 4
Issued: August 2013
ADI means Acceptable Daily Intake and NOEL means No-observable-effect-level. Values taken from Australian ADI List, 31st March 2012
Personal Protection
The following Australian Standards will provide general advice regarding safety clothing and equipment:
Respiratory equipment: AS/NZS 1715, Protective Gloves: AS 2161, Industrial Clothing: AS2919, Industrial
Eye Protection: AS1336 and AS/NZS 1337, Occupational Protective Footwear: AS/NZS2210.
No special equipment is usually needed when occasionally handling small quantities. The following
instructions are for bulk handling or where regular exposure in an occupational setting occurs without
proper containment systems.
Ventilation: Avoid high mist concentration and provide local exhaust ventilation where necessary.
Eye Protection: Eye protection such as protective glasses or goggles is recommended when this product
is being used.
Skin Protection: Wear gloves to prevent skin contact. Wear overall and long sleeves to prevent contact
Provision of eye wash facilities and safety shower recommended.
Wash hands before eating, drinking, smoking or going to toilet, launder protective clothing before re-use.
Section 9 - Physical and Chemical Properties:
Physical Description & colour: Clear orange liquid
Boiling Point:
Vapour Pressure:
Specific Gravity:
Water Solubility:
Volatility:
Flash Point
Section 10 - Stability and Reactivity
Reactivity: This product is stable under normal temperatures and pressures, when stored and handled in
accordance with this MSDS
Conditions to Avoid: Store away from heat or fire and ignition sources
Incompatibilities: No particular incompatibilities
Fire Decomposition: May evolve toxic gases when heated to decomposition
Polymerisation: Does not occur.
Section 11 - Toxicological Information
Toxicity Data: No LD50 data available for this product.
Eye Effects:
Skin Effects:
Inhalation:
Section 12 - Ecological Information
Environment: Avoid contamination of waterways.
Section 13 - Disposal Considerations
Disposal: There are many pieces of legislation covering waste disposal and they differ in each state and
territory, so each user must refer to laws operating in their area. In some areas, certain wastes must be
tracked. The Hierarchy of Controls seems to be common - the user should investigate: Reduce, Reuse,
and Recycle and only if all else fails should disposal be considered. Note that properties of a product may
change in use, so that the following suggestions may not always be appropriate. The following may help
you in properly addressing this matter for this product. Special help is available for the disposal of
Agricultural Chemicals. The product label will give general advice regarding disposal of small quantities,
and how to cleanse containers. However, for help with the collection of unwanted rural chemicals, contact
MATERIAL SAFETY DATA SHEET
Product Name: FoliMAX Phosphite +
Page: 4 of 4
Issued: August 2013
ChemClear 1800 008 182 http://www.chemclear.com.au/ and for help with the disposal of empty drums, contact DrumMuster http://www.drummuster.com.au/ where you will find contact details for your area. Section 14 - Transport Information
ADG Code: This product is not classified as a Dangerous Good for transport by road or rail
IMDG/IATA: This product is not classified as a dangerous good for transport by sea or air
Section 15 - Regulatory Information
AICS: All of the significant ingredients in this formulation are to be found in the public AICS Database.
Section 16 - Other Information
This MSDS contains only safety-related information. For other data see product literature.
Acronyms:
Australian Code for the Transport of Dangerous Goods by Road and Rail Australian Inventory of Chemical Substances Office of the Australian Safety and Compensation Council CAS number
Chemical Abstracts Service Registry Number International Agency for Research on Cancer International Marine Transport Dangerous Goods National Occupational Health & Safety Commission Standard for the Uniform Scheduling of Medicines & Poisons Safe Work Australia (formerly ASCC and NOHSC) UN Number
THIS MSDS SUMMARISES OUR BEST KNOWLEDGE OF THE HEALTH AND SAFETY HAZARD INFORMATION OF THE PRODUCT AND HOW TO SAFELY HANDLE AND USE THE PRODUCT IN THE WORKPLACE. EACH USER MUST REVIEW THIS MSDS IN THE CONTEXT OF HOW THE PRODUCT WILL BE HANDLED AND USED IN THE WORKPLACE. IF CLARIFICATION OR FURTHER INFORMATION IS NEEDED TO ENSURE THAT AN APPROPRIATE RISK ASSESSMENT CAN BE MADE, THE USER SHOULD CONTACT THIS COMPANY SO WE CAN ATTEMPT TO OBTAIN ADDITIONAL INFORMATION FROM OUR SUPPLIERS OUR RESPONSIBILITY FOR PRODUCTS SOLD IS SUBJECT TO OUR STANDARD TERMS AND CONDITIONS, A COPY OF WHICH IS SENT TO OUR CUSTOMERS AND IS ALSO AVAILABLE ON REQUEST. Please read all labels carefully before using product. This MSDS is prepared in accord with the NOHSC document “National Code of Practice for the Preparation of Material Safety Data Sheets” 2nd Edition [NOHSC:2011(2003)] MATERIAL SAFETY DATA SHEET

Source: http://nuturf.com.au/commerce/nuturf/msds248.pdf